FAQ

What is the difference between end grain and edge grain boards?

The surface o fan end grain cutting board resembles the end of a 2x4 and is easily recognized by the “checker board” pattern created.These many short pieces are stood up vertically and glued together. This type of construction allows the crafter to create a simple board or one this unique and eye catching. Major advantage of this type of board is it's durability, it can take the abuses of a knife and at the same time preserve a knive's edge.

The surface of an edge grain cutting board will look like the side of the 2x4. These strips of wood turned on edge with the length of the grain visible and glued together in parallel. With this type of construction the woods patterning or figuring of the grains comes through. You see it's  natural beauty. The downside of this type of board, after long term usage, is it begins to show cuts and scratches.

Will my cutting board be the same as the picture?

What will be the same are the stated wood(s) used to create the board. I do not use any dyes or stains to create the boards color...mother nature does that part. So due to the uniqueness of wood the colors and hues will be different from board to board.

After several year of use, can my board be made to look new again?

Click here to go to the Care and Maintenance page, scroll to the bottom and look for Revitalize/Restore.

The surface of the board feels rough or looks “fuzzy”, is there something wrong with the board?

No, this is normal; when wood gets wet it raises the grains of the wood. Simply continue to use the board as usual and over time the “fuzzy” ends will wear off and the board will smooth out. Another option is to lightly sand using a superfine sanding pad or 400-500 grit sandpaper, by hand, to knock down the raised grain. Using a courser paper will open the wood pores and you will be back to square one.

Why does the surface of the board have "ridges" where the wood is glued together?

This is normal and there is nothing wrong with your board. Wood expands and contracts with temperature and humidity of the surroundings it is in; however, the glue used to create the boards does not. So these "ridges" are the glued joints. If the ridges develope, simply use 220 sandpaper (orbital sander preferred method) to sand the surface smooth again.

Can I clean the board in the dishwasher?

Absolutely NOT!! The temperature is too high and the constant subjection to water will damage your board. Only hand wash after each use with warm, soapy water, rinse, and dry thoroughly.

My board is warping; why and can it be fixed?

Most of the time it can be fixed, but it will take some patience. The usual cause for this happening is the moisture is out of balance within the board, one side is dryer than the other (visually this will be the concave side). To fix this issue moisture has to be added back into the board, so run the board under water to wet it. Allow the water to absorb in and now wait. Repeat as necessary, eventually the board should flatten itself out. Now, let’s make sure to condition it liberally and keep it conditioned. Again, patience is required; this is not an immediate response in the board.